A spacer for corrugated roofs

height: 21 mm

width: 42 mm

depth: 25 mm

diameter: 40 mm

I just needed three more spacers and did not  want to buy 50 at the DIY store. 
After it was finished I found a few spare ones in an abandoned drawer…

Printed in PETG, because it gets quite hot on a roof. It is meant to be used with plastics corrugated sheet roof tiles.

The first try failed, I had activated brim, but the shear forces during printing were too much and it was torn off the plate halfway through printing. With the organic supports attached at a few places it worked.