Turns the horrible finger destroying socket wrench on generic fingerboard tools into a usable semi-ergonomic tool. comes together easily with a LOW TEMPERATURE glue gun. made with tinkerCAD.

         Print Settings:

0.2mm layer height

4 wall lines

15 top/bottom layers

15% gyroid infill

brim on

no supports

(if this turns out breaking, I will turn up the wall lines and infill density and would recommend doing the same)

         Assembly Instructions:

print the part in the provided upright orientation

use a LOW TEMPERATURE glue gun to fill the hole in the top of the part with hot glue

working quickly, shove your generic fingerboard tool into the hole, with the screwdriver side sticking into the smaller hole within. 

if the tool gets stuck on the opening, twist it around until it fits and keep pushing it in.