Basically wanted to have my own giant ashtray, that doesn´t spill everything all over the place in case one knocks it over the edge.

This ashtray has its own lid, that covers the top effectively while keeping the 6 slits to put your cig or what not in there. three of them are 7mm or .275 inches wide, while the other three are 8mm or .314 inches wide, to acompany normal and small sized filters.

The funnel shaped area helps the ash to fall through the hole in the center. The body is 120mm or 4.72 inches wide with a wall thickness of 2mm or .079 inches. The total ashtray (with top and lid) is 112 mm or 4.41 inches tall and 126 mm or 4.96 inches wide.

I highly recommend printing the top in its final oriantation (not upside down) in order to keep a nicer finish that isn´t to jagged.
I made chamfers where I saw them fit, while keeping some edges intentionally without them, e.g. the lid, so it holds on tight.

If you have ideas for improvement of the design let me know or feel free to make a remix.

This is my first upload despite having designed and printed a couple of pieces before.

Anycubic

i3 Mega X

Yes

0,2 mm layer height

50%

suggest printing the top in its final orientation (not upside down). Though I´m satisfied with 50% infill for some of you 100% might be more satisfying.