This is a long and low desiccant box with a lid to fit in the bottom of a filament drybox, with a lid to help prevent spillage and dropping tools into the desiccant.

Dimensions are approximately 120mm x 40mm x 25mm. Tolerance on the lid is about 0.2mm between the inner lip of the lid and the outside of the box - if your printer has less accuracy than this, some post-processing may be necessary. Uses about 38g of PLA at %100 scale.

Wanhao Duplicator i3

No

No

0.2mm

Doesn't Matter

I hit this with a couple layers of clear protective spraypaint after printing - since it's meant to hold desiccant as it's getting wet and soggy, I hope this will protect the PLA from moisture.