Do you have an Aeroscout and want to quickly FPV it! Well now you can!

All you need is a AIO FPV+VTX Combo from amazon, a cheap one I use is this FPV Camera 3-in-1 System [1]. You also would need a receiver and I use the VR02 from betafpv [2]. 

Next print the file's AeroscoutFPV_Ver2_Top, AeroscoutFPV_Ver2_Bot and Aeroscout_Mount. 

The Top component snaps into the bottom component to protect the camera and battery. M3 holes are present just in case you want an extra sense of security. Holes are for M3x6mm. 

Next you can mount the camera equipment and battery into the box. The hole for the camera is built for the Wolfwhoop WT03 [1]. 

                                                Figure 1: Top View of Loaded Box

The extra gear attached to the Camera is a voltage regulator to XT30 connector. This is completely optional, but I do so because I wanted to use the 2S 450mAh BetaFPV LiPo [3].

Once the box is assembled you can then slip the top component in and begin to mount it to the aeroscout. The Aeroscount_Mount is remixed from build Aeroscout S Action Camera Mount made by JPS99 on Thingiverse [4]. The mount is first screwed on to the three pins that lock the aeroscout's wings in place. You can then adjust the box to wherever you want on the mount (There are guide rails on either side so the box is in the middle) and then you can superglue the box down. 

And that's it. The mount should now be securely attached to the plane and the mounting box should be securely attached to that too. Before first flight just make sure to check CG and connect the XT30 Connector's (Or whatever battery) and bind it to your FPV goggles. 

References: 

[1] Amazon.com: Wolfwhoop WT03 Micro FPV AIO 600TVL Camera 5.8G 25/50/200mW Adjustable Transmitter with Cloverleaf Antenna for Mini Aircraft : Toys & Games

[2] VR02 FPV Goggles – BETAFPV Hobby

[3] 450mAh 2S 45C Lipo Battery (2PCS) – BETAFPV Hobby

[4] Aeroscout S Action Camera Mount by JPS99 - Thingiverse