Hello everyone! Having become the proud owner of the Creality K1C printer, I also didnt like the installation of a coil with a filament at the back of the printer. I did not like installing the spool on the side panel, because I didnt want dust and dirt to get between the acrylic wall and the mount. I've been looking for something that would suit me for a very long time, but I'm not satisfied with any option. This option turned out to be the closest: https://www.thingiverse.com/thing:6922253 but in my case, the spool had to be installed parallel to the back wall of the printer. By redoing this option, I got something that was perfect for me.

Features:

• the mount is installed at an angle for small tables;
• a standard axis from Creality is used as a axis, nothing needs to be printed;
• the option is made easier by cutouts, while holding a spool weighing 1 kilo filament calmly;
• it is attached via a screw to a tabletop up to and including 25 mm thick;
• the spool does not scratch the surface of the table, there is a small the gap, which perhaps should have been made larger by increasing the height of the bracket