I printed this sword for my son for his birthday (incredible model!), but was looking for a good way for him to store it. I thought about making a wall rack, but was inspired by some other similar designs & decided to make something from scratch.

I thought about making it as one piece and doing filament swaps, but decided to go with multiple pieces that attach by 3 screws from the bottom.

I recommend using fuzzy skin on both parts to get the grass & stone textures, and I personally used "sawtooth" pattern (SuperSlicer) for the top surface of the grass to get a bit more texture there.

VoronDesign

Voron2 350

No

No

0.3

10%

Print Grass & Stand in the same way it'll be assembled (hole facing up). Nameplate would be printed face down/pins up.

Nameplate is included so you have a template for the pin locations if you make your own (or if you happen to have a son named Zeke!)

Use M5 Screws (20mm length should be fine) to attach [Grass] to [Stand] from underneath.