Some of you have probably noticed the status indicator lightbox in the front of my TAZ, and possibly that I have never really published those files. The main reason is that the project requires electrical modification and firmware modification. This is definitely a proceed at your own risk, and only if you have the appropriate level of hardware and firmware knowledge to proceed. For that reason I am specifically NOT including the firmware instructions here, though you can probably find them in the build thread somewhere.

Build thread: https://forum.lulzbot.com/viewtopic.php?f=16&t=2134&p=12802
Picture of it in operation: https://www.youtube.com/watch?v=huuQKAljBeg
https://youtu.be/xQqZEzUxSpg
Link to get the electronics: https://store.makerstoolworks.com/collections/electronics/products/mm3-rgb-led

LulzBot

TAZ 5

No

No

0.5mm nozzle

I printed it at 85%, but it isn't structural so it doesn't really matter.

This was printed in ABS, but anything should work.