Wall mounted magnetic tool holder for small hand tools. Design uses Command-Strips perfect for rented/shared-spaces. 

Model is set up with 40mm magnet spacing for smaller tools. Although, alternate holes could be skipped for larger tools. Magnet holes are press fit for 10mm x 3mm disc magnets. Holes in the main body accept up to 10mm x 5mm for heavier tools requiring more magnetic holding. Superglue can also be used.

Print settings

Most all settings will work with this model, as tolerances are not tight. 0.2mm Speed was used in the Prusa grey filament for the pictured prints. Brim recommended for PLA on textured bed but is fine on the smooth sheet.