I wanted a mount to hold my Pi V1.3 and a DROK USB light I got sent in Amazon package. You can still buy them - they are very bright and very small.

I found a lot of the cases for the Pi Camera printed slightly off for my V1.3 board - so I designed this one so it fits better.

The led mount is designed for the DROK LED and a USB Extension cable - and there are insets that capture the USB when you close the back.

Case is held closed with some M2 screws. It mounts to the pivot with an M3 bolt. The pivot can be attached to the mount / flat surface of your choice.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament:
Prusament PETG Orange

Category: 3D Printer Accessories