This is a New Style Tea Lamp made with Just 3 Parts 

1. Base Part
2. Inside Stencil
3. Lamp Cover

I made this based on Flameless Candles we can find in Aliexpress. You can use any Light Source or DIY a light Source. You might have to adjust the base accordingly. Max diameter is about 43mm for the Candle

I have used PLA for the entire process but you can try with PETG (Might give better results) 

You can use 3 colours for 3 Parts or you can use same colour for Stencil and Base

Stencil can be removed any time and swap with another Stencil giving it a another look

Printing Instructions

Base Part

• 0.2mm Layer Height
• Use Input Shaper Profile for Quick Print
• 15% Infill
• No Supports

Inside Stencil

• 0.2mm Layer Height
• Use Input Shaper Profile for Quick Print
• 15% Infill
• No Supports
• Open side to the Top

Lamp Cover

• Used Spiral Vase Mode with 0.2mm Layer Height
• Default setting for Spiral Vase Mode was used (No change was made)

Fixing Instruction

1. Print all parts accordingly (Only 3 Parts)
2. Slide the Stencil inside Cover 
3. Light up the Candle the place it on the Base
4. Put the Cover+Stencil on the Base and ta-da 
5. ENJOY ! :)
    

Thank You