Lampshade built with 11 printed pieces + 6mm wooden rods + 5 triangular paper sheets.

Parts can be printed without support on my printer.

Hope you like it.

print these pieces:

• 1x 01 top
• 5x 02 middle
• 5x 03 bottom

the middle part was the hardest part to print for me so I added some STL files with a thin base layer so they stick better to the building plate.

cut 6mm wooden rods to length (you can buy these at a DIY)
5x 223mm (top to middle)
5x 230 mm (horizontal middle)
10x 215 mm (middle to bottom)
5x 160 mm (horizontal bottom)

Assemble the wooden rods & plastic pieces. Use a pencil sharpener to sharpen the rods if you can't push them in easily.

print the paper triangles 5x on paper or board material and cut them. (I attached them to the rods with some sewing thread.)