I have a small child and we have somehow accumulated several different syringes. I needed a place to better store these syringes so I modified this holder to fit my needs. The honeycomb is large enough to fit most syringes and short enough so one can be retrieved using only one hand without issue. I also added holes to the bottom of each slot and raised the model by adding feet to prevent water or moisture from collecting in the bottom of the holder. Due to the model being slightly raised, I did enable support. The supports were only on the bottom of the print and were easy to remove. Changes Made: - Raised by addition of feet - Holes were added to each slot - Model was shortened and made slightly larger - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Printer: Bambu P1P Nozzle: 0.4mm 0.16 Optimal settings Wall Loops: 2 Infill: 15% Infill Pattern: Grid Enable Support: Yes Type: Normal (Auto) Style: Snug On Build Plate Only: Yes Bambu PLA Matte Yellow Time: 4H 10M Filament Used: 124.82g ┏┓┓┏┏┓┳┓┏┓┓ ┏ ┗┓┣┫┣┫┃┃┃┃┃┃┃ ┗┛┛┗┛┗┻┛┗┛┗┻┛