Due to the pricing policy of Ruckus Wireless (Commscope), I designed and printed a free and cheaper variant of the ceiling and wall mounting plate.

There are two variants:

• Standard: good support surface and relatively close to the original.
• Minimal: very small version that also has cutouts for cable ties, not really recommended for permanent mounts.

Due to the material, both versions are not very stable at the pins and mostly only usable for one-time mounting. Also the transport of the printed plates should be done with care to not damage the pins already before mounting. When slicing, it is best to ensure that the pins are completely felt and NOT hollow or too weak!

By the way: removing the rubber feet on the R320 is no longer necessary with this plate ;-)

I would be very happy about remixes and pictures of assemblies with it.

Tested models:
Ruckus Wireless R300
Ruckus Wireless R310
Ruckus Wireless R320
Ruckus Wireless R350
Ruckus Wireless R500
Ruckus Wireless R510

All newer indoor access points.
Attention: Please do not drop your new access points from the ceiling because of a broken print! Please only use these plates if you are really sure and I do not take any warranty or liability!

Creality

Ender 3 Pro

No

No

80%

Infill at the Pins must be max!