Summary

THIS IS A WORK IN PROGRESS! DOOR AND HINGE NOT YET DONE!

This is a DIY enclosure for the Creality Ender 3 V2.

Printed parts list:
(OPTIONAL) 1x hacksaw_block
16 x 4_mm_plexiglass_fixing
8 x 20x20_three_way_corner

All other printed parts that is included in the download but not listed above is so that you can make other stuff.

Bought parts list:
Square aluminum tubes:
4x 20x20x800mm
4x 20x20x600mm
4x 20x20x500mm

Plexi/Acrylic:
2x 800x600x4mm
2x 800x500x4mm
2x 600x500x4mm

Tools:
(OPTIONAL) Multicutter
Hacksaw
Jigsaw
Sandpaper
File

using 20x20mm square aluminium tubing with 1.5mm walls and 4mm thick plexiglass/acrylic sheets.

Print Settings

Rafts:

Supports:

Resolution:

0.24

Infill:

Filament: Clas Ohlson Universal PLA Black

Post-Printing

Step 1

Clean up all printed parts, remove elefant foots with either sandpaper or a utility knife with a fresh new blade.

Step 2

Leave the protective film on until you are done working on the plexi/acrylic sheets!
Cut the plexiglass/acrylic sheets with a jigsaw with a fresh new blade for metal. It is important to use metal blade so the cut wont splinter.

Step 3

Cut the aluminum square tubing using your preferred tools. I used a hacksaw and the provided hacksaw block to ensure the cuts are 90 degrees.
Clean up the aluminum square tubing ends. I used sandpaper and a file to remove sharp edges on both inside and outside.

Step 4

Assemble the frame using the 20x20_three_way_corner to ensure that everything fits nice and snuggly and dissasemble the frame again.

Step 5

Mark up the positions for the 4_mm_plexiglass_fixings on the plexi/acrylic sheets.

30mm spacing, 50mm wide and 5mm deep pockets. I used an angle for this and a multicutter.