This is likely a 1-OFF design for my particular TV and Antenna, but I'll share all the same.

The TV in the Kitchen is an old Panasonic, and wife won't let me mount a new one to the wall (I haven't broken her down yet). Nonetheless, because I watch MeTV (What's wrong with that?) I have a digital antenna that picks up the signal fine. But there is no good place to mount the antenna (see earlier comment about wife). So...needed a different solution.

I've included the STEP file for remixes for possible similar TV profiles. The design itself is lightweight, super simple and only 4 pieces, no glue required. It prints <3 hours more than likely.

Assembly

2X the profile shape.

2X the lock bar.

Slide the lock bars into the groove and add the antenna. Done.

If you need help with the shape, let me know.