This is a set of remote control holders that adhere to the wall using 3mm thick foam tape. It allows for the free combination of boxes with different specifications from top to bottom, accommodating any number of different remote controls. Of course, you can also use it to hold mobile phones, whiteboard markers, and so on.

How to print:

No supports or brim needed; print directly. The inner dimensions of the box are 60mm x 22mm x 80mm (Length x Width x Height).

You must use the top box as the starting box, after which any number of middle boxes can be connected.

If using a thin or thick box, this box must be placed at the bottom as the thickness of its bottom is non-standard, preventing the connection of additional boxes.

Customization:

Customize the dimensions of the box according to the specifications of your remote control: use the .f3d file and adjust the following parameters yourself:

innerLength: the internal length of the remote control box
innerWidth: the internal width of the remote control box
innerHeight: the internal height of the remote control box
thickness: the thickness of the box frame
angle: tilt angle
tapeThickness: the thickness of the tape you are using
middleBoxInnerWidth: the internal width of the middle box. Note: It defaults to being consistent with innerWidth. If it is not, this box can only be used as the bottom box and cannot connect to additional boxes.