Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone) (Customisable)
Sunny Cage
Mit KI Ähnliches finden
Druckprofil(0)
Modelldatei(0)
0
0
0
Veröffentlicht:2025-12-19 11:01:30
0
0
000Beschreibung
Modellquelle
Rezensionen(0)
Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019
This is originally designed for connecting to OpenLog Clones
I used P100-E2 probes for this
Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]
FYI if programming openlog connect above to
AVR ISP
[MISO(1)][VTG(2)] [SCK(3)][MOSI(4)] [/RES(5)][GND(6)] [MOSI(1)][VTG(2)] [NC(3)][GND(4)] [/RES(5)][GND(6)] [SCK(7)][GND(8)] [MISO(9)][GND(10)] Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types
Print instructions
Category: Electronics Summary
Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019
This is originally designed for connecting to OpenLog Clones
I used P100-E2 probes for this
Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]
FYI if programming openlog connect above to
AVR ISP
[MISO(1)][VTG(2)] [SCK(3)][MOSI(4)] [/RES(5)][GND(6)] [MOSI(1)][VTG(2)] [NC(3)][GND(4)] [/RES(5)][GND(6)] [SCK(7)][GND(8)] [MISO(9)][GND(10)] Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types
Modellquelle
Original-Link: Details anzeigen
CC-BY