I was looking for an enclosure/holder for a voltmeter and temperature display, but couldn't find anything existing that was what I was looking for. I built these to screw onto the side of my printer enclosure (Stuva cabinet from IKEA).

To install, just snap the display into the enclosure and screw the enclosure onto whatever surface you'd like. I drilled a hole to run the wires through and then installed the display, so the hole is hidden.

The displays I purchased and used were:

Voltmeter: http://www.dx.com/p/203339

Temperature: http://www.dx.com/p/417909

They are identically sized, obviously.

Print Settings

Printer Brand:

RepRap

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

How I Designed This

Modelled in 123D Design. I have included the .123dx file, so you can modify it as you see fit.

Category: Electronics