This is a utility part to assist in perfect zeroing your X and Y axis on an AtomStack A5 M40.

You will need to do a couple of modifications to the laser chassis while installing this.

1. Move the belt retaining T-nut on the left side up to the 10 graduation printed on the extrusion:
2. Fold the belt down if there is excess:
3. Remove the axis end stop, this part will replace it, remove the two frame screws, align the part, and screw them back in:
4. Verify that the zeroing is correct by pushing the laser module into the notch on the zeroing block:

https://doslabelectronics.com/

 https://github.com/LogoiLab