Update 04.02.2023

• Added additional model (v8). This one uses zip ties, no screws required.

Description

Philips Hue remote control holder. Can be attached to any kind of rods of about 35mm diameter.

• Original Version (v1): A 16mm M3 screw and a hexnut are required to tighten the mount. Print the mount with PETG because this flexes better than PLA and does not break when bending. Print the remote control holder with the backside on the bed. The holder has a sacrifical layer which has to be cut out after printing. Stick the two parts together with super glue.
• Zip tie Version (v8): Print the model standing, use two zip ties to secure it.

Print Info

• Material: PETG
• Layer Height: 0.2mm
• Infill 15%