Single socket holder for use in 1/4 pegboard. Included 1/2 inch, 1/4 inch, and 3/8 inch with and without a stabilizer.

This was built to minimize the design and to allow a single socket to consume a single pegboard hole for use with individually purchased sockets so that they could fill in smaller areas or allow for custom configurations on the board.

One downfall, the design allows the holder to rotate which may be problematic for some, so a stabilizer was added to keep it from rotating, but the addition of the stabilizer does mean that it will consume two holes in the pegboard.

Print Settings

Printer Brand:

Monoprice

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

.1

Infill:

Filament: Monoprice PLA+ Gray

Notes:

Category: DIY