Description

Use this cute bag clip to reseal your unused miniverse ingredients! In actuality, you can squeeze to open this but it doesn't spring very well. I suggest sliding it over the edge of the bag instead.

Print Instructions

This is a bit of a tough print being so small and having overhangs.

I've tested this with various settings on a Bamboo X1C with 0.2 layers/0.4 nozzle:
- No supports
- Tree supports
- Built-in supports, V1 and V2.

No supports and tree supports produced rather similar quality.

The built-in supports provide a little bit better quality on the overhangs in exchange for the supports being tough to remove. Honestly, I think the V2 supports still look a bit messed up.

The v1 built-in looks near perfect but it took really good grip with needle-nose pliers and a ton of force to get them to break off. They did break off pretty cleanly though.