Parts to Print:

• 1 x Stand lock
• 1 x Balloon stand
• 2 x Toothpick holder

Required Items for Enhanced Stability 

• 2 x M3 screws (5mm)
• 2 x M5 screws (15mm)

Additional Items:

• 1 x Balloon
• 2 x Long toothpicks
• 1 x Cable tie

Installation Steps:

Toothpick Holder:

Insert the Toothpick Holder:

• Insert the toothpick holder into the hole located in front of the robot.

Insert the Toothpicks:

• Insert the toothpick through the holder. Ensure it is aligned properly.

Remove the Steel Ball:

• Remove any steel ball present in the assembly area.

Insert the M5 Screws:

• Insert the M5 screws (15mm) into the designated hole under the robot until the screw touches the toothpick to lock it in place.

Repeat for the Second Toothpick Holder:

• Perform the same steps for the other toothpick holder.

Balloon Stand:

Insert the Stand Lock:

• Insert the stand lock into the hole located at the center of the balloon stand.

Press Fit the Balloon Stand:

• Press fit the balloon stand into the back of the robot where the hole is located.

Insert the M3 Screws:

• Insert the M3 screws (5mm) into the two holes located in the front and back of the balloon stand.

Mount the Balloon:

• Inflate the balloon and lock it in place with the cable tie.