Yet another command strip / Tesa Powerstrip / two-sided tape mount for the openGrid system. 

I had the following design goals in mind:

• Easy to print
• Visually occupying only two slots
• Should be visually "living room compatible" from the front, having a flat surface
• Not using a directional snap, which would make detaching the grid without removing the strip difficult
• Still a strong and reliable connection (by using two bare snaps)

The plate is 1 mm thick, and your adhesive tape / command strip will also add a bit to that. Therefore, your grid will be offset about 1-3 mm from the wall.

You may need to cut your strip / tape to the right size.

Printing: Print it with the plate on the bed and the snaps pointing upwards.