Designed for a Dremel 3D45, but should print on anything that's properly dialed in.

Important: Print it laying on the left, as is, with the integrated support on the bed.

My settings:

FlashForge PRO PLA, rated for 190-210

• 220 deg
• 55 deg bed temp
• 100% cooling from layer 3
• 0.3 layer height
• No supports – required supports are integrated in the model
• 70mm/s, first layer 20%
• Z adjusted to just barely stick to the board, so the hinged parts don't fuse
• PEI sheet to stick well enough, but whatever floats your boat