Summary

This is a wall-mount design made for the Deco BE25.

The design allows for the mounting of a deco device on any wall or ceiling.

Simple print, used PLA+ with a 0.6 nozzle, 30% infill, and tree supports turned on for overhead angles over 85 degrees (Cura Slicer Support Option: "Support Overhang Angle")

Adaptive Layers could be enabled; for my print, I used them.

Photos are from V1.1; a new version (V1.2) has been uploaded, which allows for a simpler print with the feet at the bottom, an easier fit of the Deco device into the mount, as well as more space to wrap the cable around the bottom feet.

The mounting holes are 4mm, with a minimum depth of 6.15mm + wall insertion depth.

Step file is included!