Marking gauge - Truchino

This is a marking gauge made up of 3 printed pieces, which can mount both a nail for engraving or a pencil for marking.

Assembly requires a 12 mm diameter round bar (bushing), of any length, and two M5 screws.

Holes are provided for screwing a flat stop to correct any deformation errors of the small gauge.

Yes

No

It is advisable to print the body with a wide brim to avoid detachment and therefore deformations from the print bed as much as possible.

In any case, if the flat face of the body should be deformed, holes are provided for fixing a straight surface, as shown in the images.