This is a minor remix that I hope to be handing out to folks at the next BlizzCon!  A simple scale down and an opening to thread a lanyard through, should be a super simple print.

Lanyard opening is 3.5mm x 20mm, so the normal lanyard we get at BlizzCon will fitt.

The print in the photo was printed on the Prusa XL with 2 toolheads:

• Polymaker Marble PLA
• Polymaker Dual-Color Blue-Silver Silk PLA

On the XL, with organic supports, I can print 70 of these at a time.  Questionable if I need the supports, but I like to be sure of a good print.