Monkeys were trashing out my rubbish over the pavement even though the lid was secured with Bungee Cords. I saw a trash lock design by tymbo13 but I couldn't get my trash can lid to be secured properly so I did a remix of that design and here are the list

1. Remix bolt hole by relocating and using M8 hex bolt and nut
2. Remix arm by adding a slot
3. Print a lock pin. It has a hole for tying garden wire and attached to the top lid bolt

Used 25% infill on the print and used CHEP ExtraFast 0.28 Cura 5.0 profile with tree support and touching buildplate setting.

Creality

Ender 3

No

Yes

0.28

25%