This stand is designed to hold 330ml cans. It fits perfectly in the fridge and helps organize your beverages. The structure consists of several parts connected using pins.

The model has not been test-printed yet, but based on calculations, the can should fit properly and not get stuck when being removed. A clearance of about 5mm is included in some areas, so it's important that the printer is well-calibrated. The model is quite large and may be heavy once printed,  so keep that in mind before starting the print.
If, by any chance, something doesn't fit properlu _ I apologize and would appreciate your feedback D: 

Approximate can dimensions:

• Diameter: 58mm
• Height: 146mm

Printing parameters:

• material: PETG
• speed: 80-100 mm/s
• layer: 0.3mm
• infill: 10-15%
• supports: no
• nozzle 0.4mm

Printing Guide
For a complete set, you need to print the following pieces:

• large pin: 26 pieces
• small pin: 2 pieces
• main 1-4: 1 piece

Assembly Instructions:

1. Insert 26 large pins into the Main parts.
2. Insert 2 small pins into the Main parts as well.
3. It is recommended to use glue for better stability

NOTE:  There are 2 versions of the pins with slightly different sizes for a better fit.