Extension of the famous Ikea Lack table, in particular this creation was made for the realization of a rack cabinet for my network devices.

Print Settings

Printer: Creality CR10S

Rafts: No

Supports: Yes

Resolution: 0,2

Infill: 100%

Required Hardware

Nothing.

If when the print is finished the piece should fit together, if you want, as I did, I added some glue.

Assembly

Assembly is very simple:

- assemble the table as per Ikea manual;

- remove the chipboard caps that act as a cap to the leg, do not hammer or push, I pierced with with and I removed everything with pliers;

- if you want to put some glue, and insert the printed piece into the space, with a little force but without exaggerating, the leg could break.