Christmas is around the corner and why not use your printer to do some decoration?

This is printed in the same layer. Can be made with a Bambu printer too. For this print i used my trusty Sidewinder X2 and just changed filament color as i wish.

STEP File included in download folder. You may modify or sell this model. Just mention me. Enjoy!

Instructions:

Important!!! Check bed adhesion! It's a must for these kind of prints!
Every STL is a color and named. You can change the color as you like but the results may vary.
Every color (STL) is printed separate, unless you have a multicolor printer (i don't).
Load all files together so they are positioned in place.
Start with the color that has the smallest print and go from there. Black is almost always the last to print.
Print the Backplate last. It fits perfectly and can be pushed to close. No glue needed.
You need cheap white or rgb ledstrips. You can buy it from Aliexpress or every other place. Recomend WS2812b if RGB. They are cheap and good.
Peel the tape of the led stripe and stick it in the side of the inner walls, near the backplate as possible, so the light difuses evenly.

Have fun printing it and thank you.

Print Settings:

-For better results do a first layer height of 0.24mm
-0.2mm layer height for the rest of the print
-One Wall perimeter only for the colors!
-Z-Hop/Lift Z: 1.2mm. This is necessary so the nozzle won't hit the colors already printed. The color layers are between 0.6 and 1mm height
-This fits a 300x300 bed size and it can be resized, except Z axis (it must be 0.8mm high for the colors! Don't resize Z axis)

Post your makes and if you like my models, consider following me. Your support makes all the diference.