Printing: 

Main Gouge Clamping Body - 40% infill or higher, print on flat backside

Lower Hinge Post and Assembly - 75% infill, 10mm brim, print vertically

Main Clamping Body - 40% infill

Horizontal Base - 20% infill

Follow JL Designs document if you have printing issues otherwise.

------------------------------------------------------------------------

Parts needed:

2 - ¼-20 Nuts

2 - ¼-20 Bolts (~2" and 1")

1 - ¼-20 Flat washer

Thin Hair Tie

------------------------------------------------------------------------

Assembly:

Main Gouge Clamping Body takes a ~2" ¼-20 bolt and nut. Place nut on inside and thread the bolt. Insert the Main Clamping Body inside the Gouge Clamping Body.

Attach Gouge Clamping body with 1" ¼-20 bolt, make sure the sides with the dimples face each other. Add washer and nut. Bolt should be cut to barely have threads poking out from nut. If too long, can come in contact with wheel/tool bar.

Helpful to have ¼-20 Hex bolt tightener: https://www.printables.com/model/1130432-5-lobe-14-20-hand-knobnut

------------------------------------------------------------------------

Usage:

TTS-100

Use TTS-100 for tool bar setting, reference profiles for the angle/grind you want. 

Insert gouge into main clamping body and lightly tighten. 

Use TTS-100 for tool protrusion. 

Put Lower Hinge and Post inside horizontal base. Attach base to tool bar. 

Sharpen!