Artec Dragen

• Reduced quality (~100k)
• Turned up and bottom
• Some manual added support for faster printing
  (no support function needed !
• 65mm tall

Now as derivate ;)

I added some supports to the most important parts by myself with sketchup and resized it to 65mm.
If someone wants to print it larger, just scale it up with netfabb ;)

My print was with 0,2mm Layer, 30mm/s and again no Infill, took 1:44 hour to print :)

After printing just remove the support parts (shown on one of the pictures)
Beware the parts are very delicate ! (i broke one of the fingers off when removing the support :( )