A 3D printable, simplified firewall for the Flite Test Tiny Trainer. The original is made out of wood, but this works just as well! The hole in the middle is for the shaft to pass through and the four holes on the edges are for screwing on an X bracket to which you mount the motor (the X bracket should come included with your bldc motor - here's my motor.) Tip: I used the wood screws that come with 9g servos to mount the X bracket onto the firewall. The cut-out at the top is for passing the wires through. After the X bracket with the motor is screwed onto the firewall, you can use tape and hot glue to secure it onto the Power Pod. A tip for printing: use 100% infill to make it as strong as possible, you'll need it for the crash landings! Regular PLA is plenty strong.