Summary

Premise: this is just a remix of an existing design.

I do not take any credit for it. I simply collected the various parts in a single stl, trying to optimize the distribution. If you want different hands, look at the one i used as base.

All the pieces needed to make the robot, minus the sword, grouped into one single stl, with approximately 15x15 cm footprint. Both hands are fists with hole.

The pieces are arranged in such a way that the tallest are located near he center of the group (and plate), where the errors on the Z axis should be minimal.
The distribution should also maximize extruding vs travelling movements of the head.

The 1.1 version fixes the leg insert: there was only one and was not horizontal. The file is also significantly smaller, as side effect of exporting it with Blender, instead of Cura.