This simple umbilical mod is made for the Voron 2.4 with BTT EBB36 CAN Toolhead

All you need is some filament (1,75 mm) for the guides and 1x M3 heat insert for the anchor.

Print as many guides as you like, 5-6 should be enough for the 350x350 bed.

Replace the original cable cover by the umbilical version. Feed the CAN cable through the hole. The hole is big enough to clear the connector. Insert the filament to the 2 holes in the cable cover.

Install the guides and space them out evenly.

Push the filament into the anchor holes.

I fixed the CAN wires to the teflon tube to avoid any tangling.

Don't forget to update your input shaper after installation.

Material: eSUN ABS+

Layer: 0,2 mm

Top Layers: 2

Bottom Layers: 2

Perimeters: 2

Infill: 40 %, Triangles