Model info

The model was used as a Chromebox holder under the shelf. 
It was captured by a hole in the profile, but the removal is not good enough, so there is a second version with holes, which is designed for better removal.

2 Models: With screw holes | Without screw holes

Printer: Creality K1 MAX (300x300x300) mm

Material: Optional, but I used PETG for extra strength

Print instructions

The recommended print settings are:

• Layer height: 0.2 mm
• Perimeters: 4 perimeters (important, to make the links strong)
• Infill: 15% 
• Material: Optional, but I used PETG for extra strength
• Expected printing time: my setup took 2.15H to print