Summary

This stand is for the Fully Detailed Ghost by BoldPrintShop

https://www.thingiverse.com/thing:527736

You will need a "Winglet_Horn_Single" STL from his design and the two STLs I made.
The Arm and the Base.

I printed the arm in natural clear in vase mode @ 0.2mm and the base @ 0.2mm 5% infill

Its made so you can take one of the winglets off and snap the model to the stand with the same magnets you used for the main model. Use clear plastic epoxy to glue the arm to the winglet.

edit: Base_V2.0 has a deeper hole to hold model better