Universal phone holder that is relatively easy to print and very strong. It requires a rubber band.

Check out how it works here: https://www.instagram.com/p/B0jWqRroo1j/
Follow me on instagram: https://www.instagram.com/b03tz3d/

Features:

• Can hold many different phones (smallest is a normal iPhone 6, I use it for iPhone XS max)
• Rubber band is hidden so it looks sleek and the rubber band doesn't get affected by sunlight as much which makes it last much longer.
• Easy to operate
• Can rotate in clicks of 45 degrees (or be used stationary)
• Easy to put on and remove
• The modular fitting can be used to print any counterpart that you can mount this on.

Creality

CR-10S

No

Yes

0.2mm

80%

Print the body and the slide without supports at 0.2mm 80%.

Print the couplings with support from printplate at 0.1mm 80% (or more).

Glue the coupling onto the body BEFORE inserting the slide and let it dry (trust me :D).

Insert the slide, add the rubber band. If you can use my vent-coupling, use that. You can also design your own and make it so that the end is a 12x12mm square that's 5mm deep. That can press fit and be glued into the female coupling.

Print the body and the slide without supports at 0.2mm 80%.

Print the couplings with support from printplate at 0.1mm 80% (or more).

Glue the coupling onto the body BEFORE inserting the slide and let it dry (trust me :D).

Insert the slide, add the rubber band. If you can use my vent-coupling, use that. You can also design your own and make it so that the end is a 12x12mm square that's 5mm deep. That can press fit and be glued into the female coupling.