These tools are designed to be used for adding screws, nuts and magnets to Tinkercad creations.  These are designed to be imported into Tinkercad and then converted into holes.

6mm Magnet - Rear Push.stl

• Press fit 6mm diameter magnet which can be removed by pushing the magnet out from the small back hole.

6mm Magnet - Side Push.stl

• Press fit 6mm diameter magnet which can be removed by prying the magnet out from the the side.

M3 Hole and Nut.stl

• Press fit M3 nut with hole for the M3 screw.

M3 Nut.stl

• Press fit M3 nut.

M4 Countersink.stl

• A hole for an M4 screw with a counter sunk head.

M4 Hole and Nut Cut.stl

• Press fit M4 nut with hole for the M4 screw.

M4 Inset Short.stl

• A hole for an M4 screw where the screw cuts into the plastic and without a nut.

M4 Inset Long.stl

• A hole for an M4 screw where the screw cuts into the plastic and without a nut.

M5 Hole and Nut.stl

• Press fit M5 nut with hole for the M5 screw.