This is the next design I reworked for printing. Uses quite a bit of filament, thinking the next one I'll see if I can reduce that amount. Look at the astro model page to understand where I started with this series. I've also included some pics of the ceramic version

Print settings for photographed model using PrusaSlicer-2.3.1 based on Slic3r:
0.30mm DRAFT Infill: 20% Generic PETG
(4) - taffy_leg_section_1
(4) - taffy_leg_section_2
(4) - taffy_leg_section_3

0.30mm DRAFT(modified) Infill: 100% Generic PETG
(4) - threaded_rod_to_table_top_connector
(4) - taffy_dished_washer
(4) - taffy_glide
 

Hardware list:
(4) 1/4-20×21.5” threaded rod
(8) 1/4-20 hex nuts
(4) 1/4” washers
(12) 1-1/4” pocket hole screws

Top 20" square
 

Assembly video on YouTube. Search “taffy table assembly video”