The Model is 200x200mm in size. You can adjust the X and Y but the Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.2mm

Filaments Used:

PLA PolyLite Black Transmission Distance: 0.3

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA PolyLite Grey Transmission Distance: 1

PLA BambuLab Basic Orange Transmission Distance: 5

This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #6 (0.56mm) swap to Blue Gray

At layer #10 (0.88mm) swap to Grey

At layer #19 (1.6mm) swap to Orange for the rest.