Raspberry Pi Camera Mount - flexibility, no screws, no other hardware required.

This is another raspberry pi camera mount. I made this by making modifications to the files below. They were great but didn't allow the flexibility I was looking for. I didn't want screws to hold the arms together, and I hate using those T4 screws for the mounting rails.

So I redid the base to slide into the rail, and all screws have been replaced with ball and socket joints. You can print as many arms as you want to make it as long or short as you want. I used 2 for me. They fit into each other so they're extendable, and the camera housing can rotate.

Remixed from and thanks to:
This base: https://www.thingiverse.com/thing:4332289 by fsgraini
The remixed arm: https://www.thingiverse.com/thing:4708849 by abogdal
This camera housing: https://www.thingiverse.com/thing:2987719 by sn4k3

Creality

Ender 3

No

Yes

.2

20%

Support required because there aren't a lot of flat sides. Camera fits pretty tightly without any padding.

This mount can be used anywhere on the ender where there's a rail which gives a lot of flexibility to the viewing angle.