I needed some economical, easy to print and stack up plant supports. These plant scaffolding were designed for soft stemmed carnivorous plants. Base version is good to support plant in 2inch pot.

Basic set is 8 printed parts composed of the following, this should be enough to support a 7inch plant tall in a 2inch pot
1) 4 pcs. plant-stake-Z
2) 4 pcs plant-stake-C or 4pcs plant-stake-Y or 4pcs plant-stake-Y

Expansion can be done going upwards by printing other parts and just stack them up.
The parts plant-stake-2C and plant-stake-2Y is designed for 4inch pots

Creality

Ender 3 Pro

No

No

0.2

10

Best printed in ASA since the plants are exposed to the sun but on some cases PLA still holds well too. Although PLA might need twist tie wires for the joints to prevent structure collapse especially if the plant is grown under the sun.

10% infill should be enough if top and bottom perimeters are set to 0.8mm. The parts are just 2mm thick.