Summary

Quick holster utilizing the belt clip from IVIUPPET
Designed to hold six 8mm diameter arrows (9mm holes)

I made this to hold silicone/rubber fletched arrows as it rests on the fletch, specifically the ones that are included in beginner archery bundles. So make your own decision if you are using feather fletched arrows.

Sliced in CURA, printed in PLA+ on an Ender 3 Pro, 30% infill, 100% infill for belt clip

I'd flip the model upside down to print, so the lower gap where the belt clip slides in wouldn't need support, but id advise support, I have not tested printing without it.