Summary

This thingi is a refinement of “The Hammerhead - Handheld Kinect Grip” By Toni Buser https://www.thingiverse.com/thing:18125
I saw a few tiny details which I thought could be done a little better. So here it is.
But the grip of Tony Buser is the mother of all.

I wrote an instructables on how to assemble the whole thing https://www.instructables.com/id/How-to-Assemble-the-Kinect-Grip-of-CatweazleMagic/
I think this might be usefull.

What you need to succeed:

• 4x Socket head Cap Screw (Din 912) M3x12 or longer
• 2x Socket head Cap Screw (Din 912) M3x25
• 6x Washer (Din 125A) M3
• 6x Hexagon Nuts (Din934) M3
• 4x Springs Du Ø4.6, D Ø0.6, L25, N10
• 1x 1/4" Tripod Screw (for sale on some Chinese web stores for a few dimes)
• 1x Knurled Nut (Din466) M5
• 1x Plain Rubber Washer SAE AS 568A NBR 219 (8.5 x 3 x 19)
• 1x piece of plain rubber I mm thick (old tyre tube or something like that)

• ¼ liter fine sand. Any type will do (although calculations have been done with north sea dune sand)

• Pair of Scissors
• Pair of side cutting pliers
• Set of Allen keys
• Piece of sand paper, any grade will do
• Two component PU adhesive
• Cheap Crimping pliers (see picture)(be sure to check the use before buying anything)
• File (just to take away a few brambles)
• Sliding Calliper
• Countersink Bore
• Ø 5 mm Bore
• Little sharp knife. Anything will do as long as you are comfortable in handling it and don’t end up cutting your own fingers off.

I do hope you will enjoy this thingi.
Regards CatweazleMagic