See V1.1 of this clip at https://www.thingiverse.com/thing:4088606, which has a reinforced bridge / span between the two sides - sometimes the print of this design will snap at the folds in the bridge while in use.

I was challenged by a peer to create a method of restraint for an RSA 2FA token dangling from a badge holder which requires no supports to print, to which I added the need to use a smaller amount of material than preceding designs intended to keep the noise down while walking.

As can be seen in the photo, the RSA dongle still uses its own method of secure attachment, and the plastic restraint remains in place when clipped inside the snap strap, with or without the RSA token in place.

LulzBot

TAZ 6

Doesn't Matter

Doesn't Matter

coarse

basic