A house number that can be viewed from the front and the side. The three parts are printed separately and slot together using box joins. 

This house number is perfect if your street address is 3, or if you want to put the wrong number on your house. 

Included Photos

The green prints were tests printed in PLA at 1/4 size. This was to make sure the design slotted together correctly. 

The black prints are at full size as designed (~ 240mm x 240mm) 

Recommendation

I printed my parts in ASA due to it being installed outside.  ASA is known for its superior UV and heat resistance which would be needed for this application (https://prusament.com/materials/prusament-asa/).  It is also known for warping during printing… and it warped like the Bloody Beetroots ft. Steve Aoki. 

This affected the overall finish of the part and required a good amount of sanding and spray paint to make the print look ready. 

If i was to do it over again I'd print with PETG as it also fairs well outside (https://prusament.com/materials/prusament-petg/) and is far less likely to warp while printing.